User manual Vortex HiFi Geo Path Optimizer (GPO)
instructions
GeoPath 2 Optimizer and GeoPath 3 Optimizer
Congratulations on purchasing the GeoPath Optimizer. Read the instructions for use before using the GeoPath Optimizer. The GeoPath Optimizer is an extremely powerful interference suppression agent for use on power lines. The GeoPath was developed to reduce the extremely negative influence of geopathogenic zones on the human organism. Even with healthy blood (proper nutrition, etc.), the red blood cells stick together if you stay in a geopathogenic zone for even 10 minutes (see picture on the right). Using the GeoPath Optimizer (GPO for short), this sticking of the red blood cells caused by the geopathogenic zone is avoided and even reversed (see left picture).
The sticking together of the red blood cells due to normal electrosmog of the power lines (NF) in the household can be avoided by using GPOs.
Construction
Technically speaking, the GeoPath Optimizers are an HF filter with a safety resistor, which prevents you from receiving an electric shock when you pull out the GPO if you touch the power contacts of the GPO.
The torsion fields of the geopathogenic zones must be extremely well informed, otherwise a negative impact on the organism cannot be avoided. Therefore, the current not only flows through the components, but also through informed objects and laser-drilled semi-precious stones to ensure maximum information of the power grid.
The components are extremely low-interference components that are otherwise only found in high-end devices. The wiring is silver-plated and informed silver solder is used. The assemblies are glued so that they vibrate as little as possible.
Thanks to the extremely well-informed materials and the specially guided current in the GeoPath Optimizer, we were able to achieve the ambitious goal of eliminating interference even from magnetic grid interfaces.
The power consumed by the circuit is a tiny fraction of a watt.
Application
The application is very simple.
In-phase connection:
Make sure that the GeoPath Optimizer is connected in the correct phase. This shows that V the contact that is to be connected to the phase. (See arrow in the picture on the left)
Use in a geopathogenic zone:
Single-phase household: Plug a GeoPath Optimizer in phase into a power outlet that is closest to the geopathogenic zone you want to work on. You can use additional GeoPath Optimizers to increase the effect; these do not interfere with each other.
Three-phase household: Plug a Geopath Optimizer in phase into an outlet closest to the geopathogenic zone. In addition, you plug a GeoPath Optimizer into each of the sockets of the other phases, which affect the room with the geopathogenic zone or are located in this room. The more circuits with GeoPath touch the water veins or magnetic grid lines, the stronger the positive effect on the critical zone, such as: a magnetic grid intersection.
LF interference suppression for devices with power packs (especially switched-mode power packs):
Plug the GeoPath into an electrical outlet as close as possible to the power supply (or power cord) of the interference source. The GeoPath makes aggressive LF radiation such as that from switched-mode power supplies much easier to tolerate. A slot in a power strip with many plug-in power supplies (especially switched-mode power supplies), such as in the office, is also an ideal place for a GeoPath Optimizer. In particular with laptops, printers (WLAN printing), WLAN routers and repeaters as well as DECT base stations and DECT repeaters, the GeoPath also helps to inform the RF radiation emanating from the devices and thus make it more pleasant.
! Caution, do not use a damaged GeoPath Optimizer. A damaged GeoPath Optimizer can result in fire or electric shock.
Do not use the GeoPath Optimizer in damp rooms. No water should get into the GeoPath Optimizer. A wet Geopath Optimizer can result in fire or electric shock. Therefore, it should not be used outdoors.